Working on it...but I have to admit, this case size is pretty inadequate for the task at hand. The width is one of those even-numbers that doesn't translate nicely into module spans due to the various conventions about how to deal with panel ergonomics. Plus, rebuilding this into something that hits that zone you're looking for looks like it'll be an ugly chore because the original build used a lot of small-width modules...and they're no fun to deal with when the patchcord snarl gets really huge. Also, that really blows the whole point of using lab gear, because we've (ie: those of us using that to "extend" the electronic palette) gone to that to get better control/ergonomics as well as arriving at wholly new sounds.
Moving to something like a Mantis would be better. Better still would be B.'s 2 x 140 hp cab, which is cheap and spacious. That would allow a better module complement, plus some interfacing for actual test gear if you opt to dive into that. Also, you really do want a "typical" voice in there so that, when that's needed, you'll have that to screw around with as well as other processors.