3 Channel Vactrol-Based Analog Filter & Distortion
If you had an Unicorn Account you could see a chart with the price development of this module and the average price asked for this module.
Dirty Dan is a very raw-sounding 10HP vactrol-based analog mixer, filter & distortion module allowing you to use both filter and distortion separately depending on the input channel used. Three inputs jacks with volume knobs are located on the front panel where the two first inputs are directly routed to the vactrol filter. The third goes through the adjustable diode-based distortion with soft/hard clipping and then to the filter. The filter is vactrol-based and has its own character. I used my own DIY vactrols but these can be swapped out if you know how to solder/de-solder. You can also tweak the filter range, Highpass level and feedback via dedicated trimmers on the back. The module has lowpass and highpass without saying this on the front panel, mainly because the highpass settings influence the cutoff pot. If the high pass knob is fully counter-clockwise, cutoff acts as a classic low pass filter knob. If you turn high pass clockwise the cutoff knob will also act as a high-pass filter in some knob settings turning it further than 12 o’clock. This way you can morph between lowpass and highpass with one knob, the cutoff knob.Either lowpass or highpass can be controlled via CV or both together via the third CV input. The level of control voltage or CV H/L may be varied with the CV H/L attenuator potentiometer.You can also disconnect the distortion from the filter via the DIST OUT and process it further with external modules. The distortion is diode-based and comes with two clipping modes. The feedback (FDBK) potentiometer sets the amount of audio being fed back into the filter circuitry providing a nice resonance to the signal. key featuresVactrol-Based Analog FilterThree ChannelsSeparate Distortion StageHigh Pass and Low PassCutoff controls High Pass and Low Pass Two Clipping ModesFeedback ControlSkiff FriendlyWrong Polarity Protectionspecs & downloadswidth: 10 HPdepth: 32 mmpower: 58 mA @ +12V / 54 mA @ -12V
This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.
Look up onDisclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.
