If you had an Unicorn Account you could see a chart with the price development of this module and the average price asked for this module.
The R-52 uses two pentodes, type 12AW6. The circuit is derived directly from our award-winning TM-2 filter, but with all the features of our TM-6 filter.A pair of bandpass filters is swept with a Vactrol(tm) control element, a resonant treble filter and a less-resonant bass filter, giving a 4-pole lowpass response.Filter sweep range (approx): bass-only 80-200 Hz, bandpass/lowpass LOW setting 300-1000 Hz, HIGH setting 800-1900 Hz.Filter resonance/Q adjustable from less than 1 to oscillation. Voltage gain approx. 2 with RESONANCE set to 10 o'clock position and INPUT LEVEL set to maximum. Both filters, or one at a time, may be selected and mixed in desired amounts using the front-panel RESPONSE control. This allows for a wide range of equalization and special sound effects. CV inputs are available for sweeping the cutoff frequency and for affecting the treble filter's resonance.Circuit distortion is less than 0.5% typical.POWER SOURCE: The R-52 should be connected to a power supply ONLY of the type described in the operating manual or as marked on the R-52. It uses +12v and -12v at 150 mA, and draws about 400 mA when first powered on (dropping to 150 mA after a few seconds). The power input is a standard Doepfer (tm) 16-pin IDC type, with the -12v pins on the BOTTOM. The pins above the +12v pin row are not used and not connected.please message for exact shipping quotes
This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.
Look up onDisclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.
