10hp Edges with integrated MIDI expander
If you had an Unicorn Account you could see a chart with the price development of this module and the average price asked for this module.
10HP Edges Clone with integrated midi interface and PSImidi which allows any TRS midi cable to be used.Edges is a bank of four voltage-controlled digital oscillators - 3x square wave channels and 1x LFSR noise or triangle channel - an architecture inspired by the music synthesis circuitry of classic 8-bit consoles and home computers. For a more faithful reproduction of these classic sounds, the square waves are generated using digital logic (timers / counters) rather than DSP techniques, and are thus free of aliasing artifacts. Each voice is equipped with a gate input, allowing it to be toggled on/off without the need for an external VCA. The 4 channels have individual outputs and are sent to a built-in mixer. Finally, a simple polyphonic sequencer allows each channel to play arpeggios or trills.Dimensions 10 HP 25 mm deep Current Draw 25 mA +12V 20 mA -12V 45 mA 5V Includes Ribbon Cable
This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.
Look up onDisclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.