Unconventional VCA/Waveshaper/Ringmodulator
If you had an Unicorn Account you could see a chart with the price development of this module and the average price asked for this module.
The Fusion VCA/Waveshaper/Ringmodulator is a complex sound processor that combines VCA, waveshaper and ringmodulator. It’s not a regular VCA; it can operate as one, but most of the power of the module is in advanced modulations – with two CVs applied simultaneously to different stages of the VCA, audio rate modulations, using ringmodulator as a waveshaper – your imagination is the limit!
Features
Full analogue design
Vacuum tube based VCA – two miniature pentodes for better gain reduction
Two unconventional CV controls – CVs are not mixed, but they control different grid voltages of the tubes
Manual VCA bias control
Manual overdrive
Input crossfader
Built-in ringmodulator
Direct switch for conventional VCA mode
Low power consumption due to miniature vacuum tubes
Specifications:
14hp
40mm depth
48mA
-69mA
Note: This is a used item, and while it is guaranteed to be fully functional it is almost sure to also contain "rack rash" on the mounting holes and have some minor scratches on the panel from use. It will include a ribbon cable, m3 screws, and a box, but not the original box.
This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.
Look up onDisclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.
