Quad Three-Way Crossfader / Mixer / Polarizer
http://www.doepfer.de/a138e.htm
If you had an Unicorn Account you could see a chart with the price development of this module and the average price asked for this module.
DOEPFER A-138e 3-WAY CROSSFADERThis Doepfer A-138e Crossfader is in excellent near mint condition and looks and works great. It has four identical units that can be used for different crossfading, mixing and polarizing applications: Polarizer: only input A is used, inputs B and C are unconnected. In this case the sub-unit works as a polarizer. In the CCW position of the control the signal connected to input A appears at the output, in the CW position the inverted signal, in the centre position no signal appears at the output Two-way Crossfader type 1: Two different signals are connected to the inputs A and C, switch is in the left position (switching contact of input B is open). In this case the sub-unit works as two-way crossfader between the two signals connected to the inputs A and C. In the centre position both signals appear with the same level. Two-way attenuator: Two different signals are connected to the inputs A and C, switch is in the right position (switching contact of input B is connected to GND). In this case control is used to attenuate signal A (between CCW and centre position) or signal C (between centre and CW position). In the centre position no signal appears at the output. Similar to the two-way crossfader but without signal in the centre position. Three-way Crossfader: Three different signals are connected to the inputs A, B and C. In this case the sub-unit works as three-way crossfader. In the CCW position only signal A appears at the output. Between CCW and centre position a mix of the signals A and B appears at the output. In the centre position only signal B appears at the output. Between centre and CW position a mix of signals B and C appears at the output. In the CW position only signal C appears at the output. Two-way Crossfader/Polarizer type 2: Two different signals are connected to the inputs A and B. In the CCW position only signal A appears at the output. Between CCW and centre position a mix of the signals A and B appears at the output. In the centre position only signal B appears at the output. Between centre and CW position a mix of signals B and inverted signal A appears at the output. In the CW position only the inverted signal A appears at the output. Useful for CV mixing: e.g. signal A = ADSR, signal B = LFO. In this case one can fade between ADSR ... LFO + ADSR ... LFO ... LFO - ADSR ... - ADSR. In addition, the inverted signal of input A is available as a separate output. Potentiometers with centre detent and centre terminal are used as controls. Width: 16 TE / 16 HP / 80.9 mm; Depth: 30 mm; Current: +10mA (+12V) / -10mA (-12V). SHIPPING WITHIN CONTINENTAL U.S. ONLY
This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.
Look up onDisclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.