Tube VCA / Distortion / Waveshaper/ Timbral Gate
If you had an Unicorn Account you could see a chart with the price development of this module and the average price asked for this module.
L-1 Tube VCA 2П2П The L-1 Tube VCA 2П2П takes its name from the tube it uses, which excels at low-frequency amplification. This type of amplification is primarily used to amplify audio, rather than the radio frequency amplification perpetrated by its predecessor. Compared to the initial Tube VCA, which makes use of a 1Ж24Б tube (which promotes high-frequency amplification), the 2П2П sounds much cleaner and is ideal for bass processing. It also features a completely redesigned circuit, a wider range, and less clicking. Tube VCA 2П2П Features Uses a 2П2П tubeGreat for bass processingEntirely redesigned circuitFEATURES:CV controls control voltage input level. 5 Volts CV covers whole GAIN range.GAIN controls amplifier gain offset. DRIVE/IN1 controls IN1 levelFEEDB/IN2 controls IN2 level, or if nothing feeded into IN2 controls feedback loop level.CLIP switch switches the device between two modes: NEG where it clips more negative half of a signal, POS where it clips more positive half of a signal. Asymmetrical or non-linear distortion. Easy to swap the Tube if broken. No soldering there - headers and screws.Power consumption: V+ 18mA, V- 45mAUsed only a few hours. No cosmetic defects. 100% working.Including Eurorack power cable
This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.
Look up onDisclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.