Controller for ribbon modules
http://store.synthrotek.com/MST-Ribbon-Controller_p_693.html
If you had an Unicorn Account you could see a chart with the price development of this module and the average price asked for this module.
The MST Ribbon module brings control to a whole new surface and fills out an already generous selection of modules designed by George Mattson. The Ribbon module pairs with Synthrotek's Ribbon Controller Touch Interface modules that are available in various lengths in both 3U and 1U formats. Control Voltage, Gate and Pulse outputs allow for mega control over pitch, modulation, quantization, volume and more! Also connect your external signal into the EXT SIG IN jack to bypass the modules on-board voltage for passive external attenuation.KEEP IN MIND - The Ribbon unit is in the 1U format so you'll need a 1U rails in your caseFeatures:Exponential taper on RIB TRS input.Separate Gate and Pulse out.Pulse Out is ~1ms.External Signal Input.Reverse Polarity ProtectionKeyed 10 Pin Power HeaderWidth: 4HPDepth: 20.6mm (0.811 in)Current Draw:+12v: 8mA-12v: 15mA+5v: N/AIncludes:Ribbon Power CableTrs 1/8" cableTouch Sensitive 1U Module
This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.
Look up onDisclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.