Scrat

Description

This is a DIY build assembled by myself of the Neutral Labs Scrat module, with four "Acorn" preset cards to modify the resonance flavor. It seems to work as it should, however given the nature of this module it's hard to tell. It makes some wild sounds. It comes with no warranty.I'm a Reverb Preferred Seller and typically ship within 24 hours.From Neutral Labs:Scrat is an aggressive sounding multimode Steiner-Parker filter with a twist: You can change the resonance flavour by plugging in components like diodes, capacitors or resistors (even LEDs and/or light-dependent resistors) directly to the front panel. Assembled modules and DIY kits come with a set of small components for experimentation. A set of preset cartridges is also available, which gives you instant access to a variety of filter sounds. You could even make your own. Or go all in and connect some jumper wires to a breadboard for pretty much endless possibilities.The 2-pole filter (12 dB/octave) supports both high-pass and low-pass mode. Even without external components or cartridges, the resonance behaviour can be changed in various ways via switches on the front panel. Both resonance and cutoff can be fully CV controlled, and the cutoff CV sensitivity can be adjusted as well.The module contains an adjustable pre-filter drive circuit, which pairs very well with the Steiner-Parker design.

This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.

Disclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.