If you had an Unicorn Account you could see a chart with the price development of this module and the average price asked for this module.
This excellent condition WMD Overseer stereo DJ / tilt filter Eurorack module was bought new and used only inside a smoke-free home. Check out my other listings, and combine with other items to save on shipping costs.From the maker:The WMD Overseer is a stereo filter inspired by those commonly found on DJ mixers and DJ software. It features two filters on one knob, stereo ins and outs, bypass switch, and a fun stereo "Tilt" function which offsets the filter cutoff frequency across the stereo field creating some dizzying stereo effects.Stereo Filter in 8HPTwo FiltersHigh-Pass and Low-Pass on one knob.Stereo Tilt function with CV controlBypass switch (action on release) for instant filter on/off controlCV over both filter's cutoff freq individuallyCV over ResonanceCONTROLSBypass Switch: Turns the filter on and off. LED will be red when the filter is engaged. Toggles on button release.Filter Cutoff Knob (the big one): Turn Left for Low-Pass filtering and Right for High-Pass filtering. No filtering in the middle. Becomes offset with CV.Filter Cutoff Switch: Switched to the left limits both filters to audible frequencies so you cannot accidentally filter out all signal. Switched to the right disables the limit allowing you to filter the signal into oblivion.Resonance knob: Controls the amount of frequency boost at the cutoff point. Will not self oscillate. Knob becomes offset with CV.Tilt Knob: In the middle applies no tilt. Rotate left or right to off set the offset to the filter cutoff on each side. Knob becomes offset with CV.Tilt Switch: Allows you to apply the Tilt function to either or both HP and LP. Left for LP, right for HP, center for both.HP - LP Knobs: Attenuverters for incoming CV over the filters.HP - LP Switch: Switch to the right sends 5V to the HP - LP knobs and turns them into independent controls for the cutoff frequency of both filters, allowing you to control both filters at the same time with these independent knobs.JacksHP: CV input for the High-Pass filterLP: CV input for the Low-Pass FilterTilt: CV input for the Stereo Tilt functionRes: CV input for the Resonance of both filtersMaster: CV Input over both of the filters, accepts -5V to +5VOther notable things:Input Impedance: 40kOutput Impedance: 220 ohmsFrequency Response: 20Hz to 20kHz +-1dBLPF Cutoff Range (-3dB Fc)Limited LPF: 22Hz to 32kHzUnlimited LPF: 1Hz to 32kHzHPF Cutoff Range (-3dB Fc)Limited HPF: 3Hz to 12kHzUnlimited HPF: 3Hz to 38kHzSignal Path: AC Coupled at all times
This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.
Look up onDisclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.