36 HP
48 mm deep
Current Draw
0 mA +12V
0 mA -12V
2500 mA 5V

Module is available as a DIY project only.

No info about availability.

Universal Host

Homemade custom module.

This is an ODROID U3 single-board Linux computer in a 36HP Eurorack module, along with a USB hub, an LCD display with keypad, and two Mutable Instruments CVpals (permanently wired into the USB hub). Since it has three front-panel USB host (not device) ports and CV output, it can interface USB-MIDI controllers to the synth without any additional computer. However, its front-panel Ethernet port also allows it to interface with other computers over the network; and because there's more than trivial computing power built in, it can run software synthesis too, interfaced to the rest of the Eurorack through the ODROID's microphone in and left/right earphone out connections.

This module requires massive amounts of 5V power, but only 5V; so it doesn't actually touch the Eurorack power bus at all, but gets its power through a 5V connection on the front panel. Any extra power fed in through that port becomes available to USB-connected devices.


submitted Jun 28th 2014, 03:37 by mskala | last Change Jun 5th 2019, 13:20 by iSapien1956672

1 Users are observing this

Affiliate Disclosure
This page contains affiliate links from eBay, Reverb.com and other partners for which ModularGrid may be compensated.


SynthcubePerfect Circuit

These merchants probably sell this module. Huh?