Module is available as a DIY project only.
This Module is currently available.
cv controller diy module
The CTRL module is a 4hp tool for any case and directed towards manipulating
CV signals. Whatever you do with those CV signals is your own mind that
connects things.
The CTRL has a button which enables you to send an
“on/off” signal or gate if you prefer. You could for example trigger things
or ‘stutter’ a CV or audio signal. If you don’t connect anything on the input
there is a 5 Volt out signal, but anything on the input will replace that
standard 5 Volt into whatever is fed into it.
The other part of the CTRL is not one but two attenuators, but with a twist.
This attenuator not only enables the signal to be muted from ‘max’ to zero
(which it does when you use the right part of the ‘centre position’), but it
also gives you the possibility to do the same with the inverted signal. For this
you use the knob left of ‘centre position’. And when you leave the input
unconnected, it will be a fade between negative 5 Volt to positive 5 Volt.
TEDDY is our new DIY sub-brand of BEAR Modules. Easy to follow builds with through hole components from a complete kit - focused on the learning process of building modules and understanding them.
From a complete kit, FOR a complete module
