U-070 Gate/Tap

U-070 Manual gate/Tap tempo

U-070 Manual gate/Tap tempo module for Eurorack / Doepfer A100 system.

From top:
manual gate button + trig/gate in + LED
mode selection button + 2LEDs
output gate length knob (in manual gate mode) / divisor-multiplier knob (in tap tempo mode) + jack + LED
gate out + LED
inverted gate out + LED

Mode selection button changes operation mode (manual/tap/toggle/tap+toggle). In tap tempo mode current tempo can be memorized by holding this buttom for a while (underlined M)

Most bottom section (gate out+inv. out jacks) is dedicated to process input directly (manual knob or gate-in in top section).
These outputs can be toggled in toggle mode – pushing button (or incomming gate) changes state of those outputs (like set/reset or division-by-2).

Mid section job differs according to mode selected:
– in manual gate mode knob sets fixed length of output gate (fixed output pulse length regardless of length of pushing or input gate length) from 1ms to 16s – can work as extender or shortener of input trig/gate
– in tap tempo mode knob sets rate of division/multiplication (/4, /3, /2, unchanged, x2, x3, x4) derived from tapped tempo or input trig/gates (this allows for example faster or slower clock from input clocks)

Jumper setting:
left jumper selects 4-tap (jumper removed) or 2-tap mode (jumper set). 2 taps or 4 taps are required to change tempo.
right jumper selects trig/gate output length in mid section in tap mode: 5ms trigs (jumper removed) or half-of-length gates (jumper set)

http://ladik.ladik.eu/?page_id=1721