8 HP
40 mm deep
Current Draw
55 mA +12V
32 mA -12V
0 mA 5V
$220 Price in €

This Module is discontinued.

Specs are approved by the manufacturer

Panner, Stereo Balance, Cross Fader, Dual VCA

Uses high quality THAT Corp. VCA chips.

Implements panning using a unique constant power panning circuit (most accurate method for controlling sound placement in a stereo image).

High dynamic range for VCA gain with 0-5V giving approximately -80db to +3dB
Separate inputs for bipolar and unipolar control of the Panning / xFading
Jumper on PCB to select bipolar voltage range: either +/-2.5V or +/-5V

Unique Vactrol based Stereo Width circuit: Used with stereo signal to vary the perceived stereo width from mono to stereo and slightly beyond using negative cross bleed.
Bypass switch to disable the Width circuit.
Dedicated attenuator for the bipolar pan CV source.

Modes: (determined via the jack normalizing/patching and mode switch)

With audio connected to the Left Input, panning control steers the signal to the Left or Right output using constant power panning.

Stereo Balance
With a stereo audio source plugged in to the Left and Right inputs, panning controls the balance between these two sources using constant power panning.

With two audio sources patched into the Left and Right inputs respectively the panning controls now act as crossfade controls. The resultant signal is is routed to the Left Output.

With the Pan control centered and the VCA gain knobs fully CCW this modules becomes a dual exponential VCA.
Separate L and R VCA CV controls but there is also a “both” control for using a single CV source to control the VCAs in stereo.


Ø 4.08 (12 Votes) Average Rating
submitted Oct 11th 2012, 20:00 by intellijel | last Change Nov 6th 2021, 19:23 by intellijel

19 Users are observing this