CTRL+

Pressure, velocity and gate touch controller

DISCOUNTED DUE TO PRESSURE CV LED (GREEN) ALWAYS DISPLAYING INTERNAL OFFSET. OTHERWISE FULLY WORKING. NORMAL RRP £129

Control your eurorack system with just a touch. Generate control voltages and gates from the capacitive touch pads and route them to play your system.
Some things just can’t be sequenced......
The module has two touchpads, one to generate CV outputs and the other for gates. There are separate outputs for the pressure CV, velocity CV and Gate.
The pressure touchpad has been designed to be expressive. The pressure CV is proportional to how hard you press the panel, contact surface area and position.
The increasing separation of lines in the pressure touchpad results in an inverse relationship to its response so that depending upon where you touch you will get a different level of sensitivity.
The top of the touchpad is more sensitive. The sensitivity decreases going down the panel.
Using just the tip of your finger the output CV can be controlled by slide it up and down the panel.
The RGB LED in the top left displays the level of each output.
Green = Pressure
Blue = Velocity
Red = Gate
The pressure CV output ranges from 0-6V
The module has been fitted with an offset trimmer which can be adjusted when the module is mounted in your rack to set the Pressure CV to exactly 0V.
The module also has trimmers on the back of the module to allow for calibration to taste. You can change the output gain of the pressure CV. There are also trimmer for the Velocity CV sensitivity and gain.
After the Pressure CV has been adjusted the offset through the panel will need to be recalibrated back to 0V using a small flat head screwdriver.
It is not recommended to adjust the other two trimmer for internal clock and balance.
Include power cable and mounting screws.

https://beepboopelectronics.co.uk/product/ctrl/