The AM1020 is a completely new complex VCO design for any Eurorack eco-system and is inspired by the discontinued Instruo Troika.
OVERVIEW The AM1020 is a completely new complex VCO design for any Eurorack eco-system and is inspired by the discontinued Instruo Troika. An ultra stable VCO delivers four waveforms that can be mixed and blended to create complex wave shapes, by using two wave shapers to create new sounds!
DESCRIPTION The VCO is based on the SSI2131 chip which delivers Triangle, Sawtooth and Pulse waveforms. A sine wave converter produces a fouth waveform. The waves are fed into two parallal wave shapers (WAVE and WAVE B) that mix two of the waves together using the slide potentiometers. The source waves are selected using a slide switch.
The WAVE A and B waveforms are available separately on jack sockets, and a combination is available on the MIX output. This output is a switch between WAVE A and WAVE B in real time and is activated by;
Pushing the MANUAL push button
Connecting a Eurorack gate signal
Using the internal or an external waveform (as it cross zero)
The subtle green LED sliders indicate which wave shaper is active in the MIX output.
The frequency of the VCO can be controlled manually across 5 octaves by the FREQUENCY potentiometer. In NORMAL mode this is 32Hz (C1) to 1024Hz (C5), and in LFO mode from 0.6Hz to 40Hz. The frequency can also be adjusted over ± 6 semtones by the FINE control, and modulated by an external CV (FM MOOD).
The VCO has sync with two strengths (weak, strong) selected by a slide switch.
There are short trimmer pots for the WAVE A and WAVE B levels and the Pulse Width/PWM. The module is designed to generate signals at 10V p-t-p and to be controlled by CV signals from 0 - 10V. There are green LED's on the wave shaper potentiometers, which represent which wave is active in the MIX output.
CONNECTIONS There are nine 3.5 mm jack sockets on the front panel:
1x 1V/OCT pitch input
1x Frequency Modulation input
1x Pulse Width input
3x VCO WAVE outputs
1x Eurorack Gate Input
1x Zero Crossing Detector Input
1x Sync Input
The module comes with a set of M3 mounting screws and washers, and a standard Eurorack 10-pin to 16-pin power cable.
https://www.amsynthstore.co.uk/product/am1020-vco-wave-shaper
These merchants probably sell this module. Huh?