This Pedal is currently available.
Delay
About
Raposa is a PT2399 delay pedal that focuses on the delay imperfections through tape warp fluctuations, dark repeats and simulation of worn out, poorly maintained tape decks.
MIX controls the blend between clean and delay signal.
REPEATS controls the number of repeats.
WARP controls the depth of slow modulation.
DELAY controls the delay time.
LPF controls the low-pass filter of the delay signal.
FAILURE controls the depth of random signal dropouts of the delay.
RATE controls the failure rate.
WAVEFORM toggle switches between softer triangle wave and
choppier square wave failures.
DIVISION toggle switches the delay time divisions set by tap tempo.
LEFT footswitch turns the effects ON/OFF.
RIGHT footswitch functions both as tap tempo and oscillation / infinite repeats on hold.
LPF control can affect the volume of the delay signal and the oscillation intensity. There are two trimpots inside the pedal marked DELAY LVL and FEEDBACK to adjust those two.
Power
This product should be used with high-quality isolated power supply. It uses 9V DC negative center 2.1mm barrel. Unregulated power supplies as well as higher voltages may result in suboptimal noise performance and even damage your unit.
Current draw for this pedal is ~110mA. Please don't underpower the unit.
Polarbear Effects Raposa