If you had an Unicorn Account you could see a chart with the price development of this module and the average price asked for this module.
***Mint condition, barely used - a few times. Sounds great. ***Legendary amp sounds at your feetThrowing the BassRig Super Vintage on your pedalboard is like adding a full-featured amp to your setup. With a flick of the Ultra Hi/Lo Cut switch, punching in additional highs and cutting out muddy lows is a breeze, crucial when going from warm-sounding cleans to gut-punching grind in the same set. The tonal tweaking only starts here, as handy controls for setting the horn cut as well as LF and HF levels polish your overdriven sound while fine-tuning the lows and highs to match whatever amp and cab you’re running, respectively.Send stage-worthy tone to the soundboard via balanced XLRWhile booming yet ear-tingling tone is the goal for many bassists at Sweetwater, two factors commonly play into the pieces of gear they decide to acquire: convenience and versatility. In the case of the BassRig Super Vintage, its wide-ranging sound is complemented by an incredibly useful DI out section, tailoring this pedal to any live or studio situation that presents itself. When wired in via the BassRig Super Vintage’s balanced XLR output, you gain access to a spot-on simulation of an 8 x 10-inch bass cabinet, channeling stage-approved sound with a single pedal. Origin Effects sweetened the pot with a DI cab sim switch — this two-position switch kicks on the cab simulation when the pedal is engaged when in FX mode, with FX+BYP mode keeping the cab sim always active.Origin Effects BassRig Super Vintage Bass Preamp Pedal Features:Analog amp re-creation of a coveted Ampeg amp in a pedalboard-friendly enclosureBlend and Drive controls balance your wet/dry signal and crank up the gain, respectivelyStandard 3-band EQ section fine-tunes your sound800/3K/220 switch sets which mid-range frequencies are controlled via the Midrange knobUltra Hi setting adds high frequencies; Lo Cut cleans up muddy lowsAmp Out EQ section with horn cut and LF/HF controls further tweaks your tone before hitting your amp and cabBalanced XLR output features an 8 x 10-inch bass cabinet simulationDI cab sim switch with engaged-only (FX) and always-on (FX+BYP) settingsDI ground switch eliminates ground loop hum when both outputs are in useTech SpecsType: Bass Preamp DI PedalForm Factor: PedalAnalog/Digital: AnalogEQ: 3-band EQInputs: 1 x 1/4"Outputs: 1 x 1/4" (amp out), 1 x XLR (DI)Bypass Switching: BufferedPower Source: 9V DC power supply (sold separately)Power Usage: 150mAHeight: 2.5"Width: 3.6"Depth: 5.7"Weight: 1.86 lbs.Manufacturer Part Number: OEX-0023-00Included ItemsOrigin Effects Bassrig Super Vintage PedalSV Getting Started GuideOrigin Effects Box
This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.
Look up onDisclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.
