High-gain distortion
https://www.jimdunlop.com/mxr-fullbore-metal-distortion/
Go to the Module Detail PageIf you had an Unicorn Account you could see a chart with the price development of this module and the average price asked for this module.
The MXR M116 Fullbore Metal delivers super high-gain distortion with a three-band EQ, sweepable mids via the Freq knob from 200 Hz to 5 kHz, and controls for Low, Mid, and High. It has a Scoop switch that boosts lows and highs for a nu-metal scooped sound while keeping EQ active, plus a switchable Noise Gate to tighten up syncopated riffs and cut noise.Volume and Gain knobs handle output and drive levels. True hardwire bypass keeps your signal clean when off. Power it with a 9V battery or adapter; draws 18 mA. Gate sensitivity adjusts via an internal trim pot for dialing in threshold.It's built dynamic, so start with Gain and Lows low to avoid overwhelming your amp. Works for crushing rhythms, leads, or tuned-down stuff with the Gate on.
Specifications
Power requirement: 9 volts DC, 18 mA current draw
Bypass type: True Hardwire
Tone controls: Low ±9 dB at 100 Hz, Mid ±16 dB at 200 Hz to 5 kHz (sweepable via Freq), High ±12 dB shelf at 1.5 kHz
Noise Gate: Switchable, internal sensitivity trim pot
Scoop switch: Boosts lows and highs
ConditionThis item has been tested and is in good working condition. It does not come with original packaging. It has Velcro on the back. No power supply included.
This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.
Look up onDisclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.
