Discrete Class-A germanium pre-amplifier
https://hudsonelectronicsuk.com/bc-24v-ltd/
Go to the Module Detail PageIf you had an Unicorn Account you could see a chart with the price development of this module and the average price asked for this module.
Hudson Broadcast limited edition and exclusive to Peach GuitarsLike new mint condition Awesome magenta housingOriginal box and paperwork included Not only does this pedal sound AMAZING, it’s signed and dated by the man himself, Michael Hudson! Germanium transistor in the drive sectionTRIAD Magnetics steel-core transformer chosen for the way it saturatesBI Technologies potentiometersHeavy duty foot switches (rated for >30,000 cycles)Individually hand-built on to a high-quality PCB, assembled, hand-wired, tested and packaged all by Michael HudsonPOWER – The Broadcast requires a DC power supply unit (PSU). Please ensure your PSU can supply 9v, a minimum current of 50mA and has a 2.1mm negative centre barrel plug. Any other type may damage your pedal. If you plan on sharing the same PSU with other pedals, we recommend using a PSU with isolated outputs.IMPORTANT!THIS VERSION OF THE BROADCAST CONTAINS A VOLTAGE BOOSTER TO INCREASE THE VOLTAGE OF THE POWER SUPPLY UNIT FROM 9V UP TO 24V. DO NOT ATTEMPT TO RUN THIS PEDAL AT POWER SUPPLY VOLTAGES HIGHER THAN 9.6VDC AS THIS MAY DAMAGE THE PEDAL AND VOID ITS WARRANTY! I DO NOT OFFER ANY TYPE OF WARRANTY. LEFT FOOT SWITCH – Bypasses the pedal (red LED indicates the pedal is active)RIGHT FOOT SWITCH – Toggles between LOW and HIGH gain modes (blue LED indicates HIGH gain mode is selected)LEVEL LOW – Controls the volume of the pedal in LOW gain modeLEVEL HIGH – Controls the volume of the pedal in HIGH gain modeGAIN TRIM – Controls the gain level (both in LOW and HIGH gain modes) of the Broadcast (at higher settings the high-end of the signal is gently rolled off)LOW CUT – Attenuates the low-end of the Broadcast (since this control lies at the frontend of the Broadcast’s circuitry, it is interactive with the gain controls)INTERNAL TRIMMERS – Sets the gain range for each mode. The LOW gain mode is located to the left and the HIGH to the right.HUDSON ELECTRONICS UK
This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.
Look up onDisclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.
