If you had an Unicorn Account you could see a chart with the price development of this module and the average price asked for this module.
This item has been carefully examined and is fully covered by Kraft Music's 45-Day guarantee. It may show signs of use and handling but is guaranteed to function as new. Take advantage of this great deal from Kraft Music today! Dreadbox Darkness is a digital stereo reverb effect pedal suitable for fretted instruments and synthesizers. Instead of having several switched algorithms, Darkness has a single versatile and flexible algorithm that can create from small and smooth reflections up to huge shimmering and endless reverbs. Experimenting is strongly suggested!Flexible shimmer reverb with gate function32-bit @ 48kHz digital effects processorVariable time scale with triangle or sample & hold modulationSelectable pitch shift ±12 semitones with variable mix amount for shimmering soundsUp to 30-second decay times2-pole high pass / low pass damping filterFreeze function loops 150ms of the input signalVersatile gate effect with variable attack and release timesTrue stereo input and outputSelectable tails bypassDarkness has a simple and intuitive control panel with deeper 'left shift' and 'right shift' editing parameters easily accessed by holding down either of its soft-touch stomp switches. ON stomp switch main function: CMOS bypass on/offHold down to engage 'left shift' knob functions. HOLD stomp switch main function: loop 150ms of input signalHold down to engage 'right shift' knob functions. SPREAD knob: adjust the reverb size. MIX knob main function: set the balance between the dry signal and the effect outputLeft shift alternate function: set damping filter cutoff frequencyRight shift alternate function: set gate threshold DECAY knob main function: set effect feedback levelLeft shift alternate function: set modulation depthRight shift alternate function: set gate attack time The MODE switch toggles between two main functions for the CONTROL knob.Position 1: set modulation ratePosition 2: set gate release time The CONTROL knob main function is set by the MOD switch.MOD switch position 1: set modulation rateMOD switch position 2: set gate release timeLeft shift alternate function: set tails on or offRight shift alternate function: set gate on or off
This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.
Look up onDisclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.
