Bass Overdrive
Go to the Module Detail PageIf you had an Unicorn Account you could see a chart with the price development of this module and the average price asked for this module.
EBS Billy Sheehan Ultimate Signature Drive. If you’ve ever wanted to blend clean and distorted bass tones without hauling two rigs, this is your answer.Parallel Signal PathsThe pedal splits your signal into clean and distorted paths—just like running two rigs. Adjust the blend with the Clean and Drive Level controls. A built-in compressor (with internal threshold control) keeps your tone tight and punchy.Low-End Punch & Gain BoostUse the Phase Inverter switch to recover lost low-end due to phase cancellation. Engage the Boost footswitch for extra gain when you need to cut through.Expanded Tone ControlA Hi/Lo Frequency Filter shifts the Tone control’s entire spectrum, unlocking distortion tones unavailable in earlier versions.Dual FX Loops for More FlexibilitySeparate effect loops for Clean and Drive paths let you process each independently. Got a bass with dual outputs? Use the Clean Loop jack to run lows clean while shaping mids/highs through the main input.All Deluxe Features—Plus MoreIncludes all features from the Deluxe model (like easy drive chip swapping), with added tone-shaping power via the Hi/Lo filter.Frequency Range SwitchHi or Lo Frequency range Switch, NEW!Boost Drive FootswitchBoost Drive Footswitch Phase Inverter SwitchPhase Inverter Switch **ControlsDrive, Tone, Level and Clean controls Compressor ModesThree Compressor Modes – High, Mid, Off *LoopsClean Loop and Drive Loop (use an insert cable, such as the EBS ICY-30 to separate send and return) *Footswitch TypeMagnet Type Footswitches, NEW!Drive CircuitReplaceable Drive Circuit (8-pin Dual Inline Op-Amp Controlling Drive Circuit) **Compressor AdjustmentFine tuning trimmers to adjust Threshold level of the compressor (THR.) and the level of Compression when the mode switch is set to MID (COMP) *Boost Switch LevelTrim pot to set the BOOST switch level inside **Power Options9V DC battery or EBS AD9 Pro Power Supply (not included)Notes Features shared with both the ‘purple’ and ‘orange’ version. Features shared with the ‘orange’ version.Nominal Input Level-8 dBvInput Impedance700 kohmsGain Range (Drive)20 – 50 dBBoostAdjustable +3 to +10 dBTone Filter Range175 – 8000 Hz (two ranges), Q 0.7 – 0.9Loops Output Impedance2 kohmsLoops Input Impedance47 kohmsMix LevelDrive +3 dB max, Clean +6 dB maxCompressor Ratio5:1 (max)Threshold-25 to +6 dBAttack Time (80%)< 7 msRelease Time (80%)75 ms (typical)Makeup Gain0, +3, +6 dBOutput Impedance< 50 ohmsDimensions (W x H x D)3.3″ x 4.5″ x 1.9″ (83 x 115 x 48 mm)Weight420 g (0.93 lb.)TypeAnalog Effect, Relay SwitchingPower Requirements9, 12 or 18 V DC, 60 mA max (shuts off below 6 V)
This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.
Look up onDisclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.
