If you had an Unicorn Account you could see a chart with the price development of this module and the average price asked for this module.
This pedal has barely been used, never taken to gigs, and is nearly new condition with the exception of some 3M Dual Lock on the back which is completely removable, but ideal for pedalboard mounting. This is one of the most feature rich overdrive/distortion pedals on the market and it's designed just for bass players. See below for a list of features. The Microtubes Infinity shares the footmark of the Darkglass programmable line, packed with our three legendary Microtubes distortions: B3K, Vintage, and X. It allows multiband compression on every mode and blending Impulse responses between distortions: an infinity of possibilities.FRONT PANEL:COMPRESSOR This control allows setting the input gain of the compressor that will translate into how much the signal is compressed while our intelligent make-up gain algorithm keeps the output of the compressor at usable levels. The compressor has 5 ratios available: 4:1, 8:1, 12:1, 20:1 and ALL IN.Drive The Drive potentiometer adds distortion and drive to our signal (modes 2-4) or blends in the tube preamp emulation (mode 1). Crank this knob to add more saturation or character to your distortion/preamp part of the signal chain.Tone·Era The Tone·Era potentiometer allows you to go from dull to crisp and anything in between. On the Vintage Microtubes (modes 2 & 4) you get the coveted ERA control which covers different decades of classic bass tones.Blend The Blend potentiometer mixes between the distortion signal and the clean sidechain signal. Touch Sensitive Sliders Each slider has a -12 dB to 12 dB range. From left to right, the frequency bands for each slider correspond to a low shelf, 250 Hz, 500 Hz, 1.5 kHz, 3 kHz, and a high shelf.BACK PANEL:Input This is the primary instrument input on the Microtubes Infinity. Connect your instrument or output from your pedal board to the 1/4” mono jack.Aux In The stereo input of the Microtubes Infinity enables the playback of backing tracks while practicing or recording. Connect your mobile phone, laptop etc. to the 1/8” stereo jack.Headphone OutputThe headphone output can handle headphones with an impedance of 16 – 600 ohms. Connect your headphones to the 1/8” stereo jack and set the desired level from the dedicated potentiometer next to the jack.Direct OutputAn XLR output with a ground lift switch provides a reliable standard connection to a mixing desk or an external audio interface for a guaranteed low-noise signal.MIDI In A standard 1/8” TRS (Type B) jack allows connecting an external MIDI controller to the Microtubes Infinity for even more flexibility.
This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.
Look up onDisclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.
