If you had an Unicorn Account you could see a chart with the price development of this module and the average price asked for this module.
Boxed, never gigged, excellent conditionDarkglass Vintage Deluxe Overdrive V2 Bass Preamp & Overdrive PedalThe Darkglass Electronics Vintage Deluxe features the warm, tube-like tones of the Microtubes Vintage and adds a 4-band active EQ, parallel output and balanced line driver.It delivers the natural dynamic response and organic compression of classic tube amps and tape machines, fitting four decades of legendary tones into a package that will fit in your gig bag.Controls:Level: Sets the volume of the overdriven signal.Drive: Sets the amount of saturation in the overdriven signal.Blend: Mixes the clean input signal with the overdriven signal. The clean signal remains at unity gain while the volume of the overdriven signal is set by the Level knob, allowing for fine control of the blend ratio.Grunt Switch: Sets the amount of low frequency content to saturate by selecting between three different bass boost levels before the clipping stage.Attack Switch: Sets the amount of treble content to saturate: The “Boost” setting emphasizes the treble content extra clarity and presence. The “Flat” position leaves this register untouched while the “Cut” position will reduce the amount of high frequencies being saturated.Low: +-12dB @ 100HzLow Mids: +-12dB @ 500HzHi Mids: +-12dB @ 1.5kHzTreble: +-12dB @ 5kHzParallel Output: A passthrough for your input signal, useful for parallel processing.Direct Output: A balanced version of the ¼” output, useful for running into PA’s or studio mixing consoles.Direct Output:A balanced version of the ¼” output, useful for running into PA’s or studio mixing consoles. The Direct Output also includes a ground lift switch – this should be pushed in (grounded) in most scenarios.Parallel Output:A passthrough for your input signal, useful for parallel processing.The Vintage Deluxe features the warm, tube-like tones of the Microtubes Vintage and adds a 4-band active EQ, parallel output, and balanced line driver.It delivers the natural dynamic response and organic compression of classic tube amps and tape machines, fitting four decades of legendary tones into a package that will fit in your gig bag.The Vintage Deluxe has a current draw of 30mA. Only use a regulated 9V DC adapter with a centre negative plug. Due to ecological reasons, it does not accept batteries. Unregulated power supplies and/or higher voltages may result in suboptimal noise performance and even damage your unit, voiding the warranty.This is now quite a bargain as there is a version 3 available. The difference is there is more flexibility on the EQ and there is an XLR output on the version 3.The sound engine is the same so, here is a link to V3 manualfor details
This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.
Look up onDisclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.
