If you had an Unicorn Account you could see a chart with the price development of this module and the average price asked for this module.
The CLYDE deluxe has some neat additions over the standard CLYDE:3 way selectable switch#1 “Wacked” is reminiscent of the old Colorsound wahs....more of a “woooooowww” withextremely deep bass response. A radical change from the standard wah tones you’re used to.#2 “Jimi” is our benchmark recreation of the late ‘60’s Vox Clyde McCoy wah wah as used byyou-know-who and Eric Clapton circa Cream.#3 “Shaft” shifts the whole range up a little to capture the ‘70’s sounds heard on all those funkclassics and bad movie soundtracks!Adjustable Gain Controlallows the user to not only fine-tune the desired volume level, but to also overdrive the wah a bitfor more overtones and grit. This control ONLY affects the “on” sound because this pedal hastrue bypass.....finally you can control your wah volume to the nth-degree!LED statusa nice bright glowing red LED to tell you when it’s on.... clean sounding PureBypass when off!Internal Resonance Control:There is an user adjustable Trimmer inside your lovely new wah that lets you change the gain andbottom-end (Bass) response...it is located on the circuit board and requires no tools to set.There is room around this trimmer for you to mark your favorite settings using any type of permanentmarker. With the wah plugged in and amp on, turn the wah over and remove the back plate by looseningthe 4 rubber feet (note: no tools required, just turn counter clockwise until they come out)With the wah situated in front of you so that the section of the unit with the battery is facing you, noticethe trimmer with a line pointing to a black arrow (this is my favorite setting) for your particular wah) Nowset the trimmer to @ 2 O'clock. that's a stock '60's Vox sound. Turning the trimmer clockwise gets moregain and Bass.True Bypass switching is essential for no tone loss when effect is off. The wah is activated by rocking allthe way forward and pressing hard with your foot. This amount of pressure needed to activate effect canbe adjusted for firmer or softer feel....simply contact Fulltone if you have any questions.The Treadle (part that your foot rests on!) is also adjustable for a firmer or softer feel. This isaccomplished by either loosening or tightening the "nylock" nut on the side of the treadle at the pivot-point where it connects to the bottom housing. It will stay put until you change it the next time.I recommend using a Carbon-Zinc 9 volt battery (included) such as the Eveready "Classic" or "SuperHeavy Duty" instead of an Alkaline, which although they last longer, tend to sound harsh. Do your ownexperiments.....leave the wah plugged in and quickly change through a couple of different types ofbatteries, but keep your amp's volume down so as not to damage your ears or the amp from the noisewhen reconnecting the next battery. This pedal is also equipped with a convenient 9 volt DC jack that isTip Negative, make note of this, and make sure the adapter you use is the same!!!
This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.
Look up onDisclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.
