Low/Band/High filter with variable band width
Go to the Module Detail PageIf you had an Unicorn Account you could see a chart with the price development of this module and the average price asked for this module.
BUGBRAND CROSSOVER FILTER The CrossOver Filter is a smartly configured pair of Resonant State-Variable Filters with Voltage Control. The playable design presents a powerful little toolbox for creatively transforming audio signals!The driving forces behind the design of the COFilter were two-fold – firstly I wanted to bring the filtering out of the Modular range so that I could make use of it more easily in the studio. But I’d also been wondering about re-imagining the Cross-Over units that often sit in PA racks to split audio into separate frequency bands – these always tended to be a bit limited/boring so how exciting it would be to make a playable and powerful design for studio usage which took a mono signal and split it into several frequency bands for further processing/panning.The circuitry of the COFilter was completely redesigned in 2019 – adding balanced input, voltage-controlled resonance and upgrading the core components. From the outside, the new version appears almost identical to the old (the only clear difference is the Drive control – now with black rather than white line). A new 2FW Expander will follow along offering individual I/O for the Filters and further CV inputs for Frequency & Resonance, with a distinct view to allow dual use for stereo processing work.
This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.
Look up onDisclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.
