Bass Preamp & Overdrive
Go to the Module Detail PageIf you had an Unicorn Account you could see a chart with the price development of this module and the average price asked for this module.
Radial Bassbone OD -- Mint ConditionIf you have any Radial gear you know that it is always outstanding quality ! This 2 channel bass preamp has a ton of capability plus includes a nice sounding overdrive. The Bassbone is a great solution for switching between two basses or just as a super versatile preamp with tuner out, mute, and overdrive.This unit has been used for less than 10 hours and is in mint condition including all the original packaging and power supply as shown in the photos. I thought that I needed this for a particular stage setup but it didn't come to pass so ...If you have been looking for one of these units you are in luck -- why pay full price for new when you can get a sweet deal on this mint used unit !!Free shipping to the lower 48 US States only - thank you.Here is the description from the Radial website:The Bassbone ODTM is a bass command center with two instrument input channels that are fully equipped with a semi-parametric equalizer and high-pass filter to eliminate low frequency resonance. Channel-A is set with a 22k-Ohm input impedance that is ideally suited for both passive and active basses. This is supplemented with a PZB booster that at once increases the output by 10dB and the load to 10 meg-Ohms to optimize it for use with piezo transducers. Channel-B is equipped with DragTM control load correction to optimize the tone and feel when using a vintage passive instrument. Toggling between channels is done using a footswitch and both channels may be mixed together by engaging the Blend switch. Outputs include a 1⁄4" stage amp out plus a balanced low-Z Radial DI box output to feed the PA system. A separately buffered tuner out works with the mute footswitch for quiet on-stage tuning. An effects loop with separate send & receive jacks enables multiple pedals to be used. This is augmented with an on-board overdrive with a wet-dry control that lets you add slight grit like an SVT or over the top distortion. The OD footswitch may be assigned to the loop, overdrive or both. Finally, a built-in headphone amp with 3.5mm output lets you use the Bassbone OD on the bus for those long drives between gigs.
This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.
Look up onDisclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.