Create incredibly smooth volume swells or control your effect pedal parameters with the Dunlop DVP3 Volume X
https://www.jimdunlop.com/product/dvp1xl-7-10137-07229-9.do
Go to the Module Detail PageIf you had an Unicorn Account you could see a chart with the price development of this module and the average price asked for this module.
VOLUME (X)™ PEDAL DVP3The Volume (X) Pedal controls volume and FX parameters, featuring fully adjustable rocker tension and and a Low Friction Band-Drive for ultimate durability—all in a pedalboard-friendly housing. DESCRIPTIONControl your volume levels or effects pedals with exacting precisionPatented Low Friction Band-Drive for highly reliable actionFully adjustable rocker tensionDIRECTIONSWe recommend placing the Volume (X) at the beginning of your effects signal chain. Run a cable from your guitar to the Dunlop Volume (X)'s Input jack.Optional: Run a cable from the Tuner output to a tuner. Signal to tuner is active regardless of rocker position.VOLUME MODE (250 kg POT)Run a cable from the Volume (X)'s Output jack to your amplifier.With the pedal in full toe-down position, set your guitar and amp's maximum desired volume level.Move the rocker pedal toward the heel-down position to decrease the volume.The output signal will be muted when the rocker pedal reaches full heel-down position.EXPRESSION MODE (10 k POT)Run a stereo or TRS cable from the Volume (X)'s FX jack to your effects pedal's expression jack.With the pedal in full toe-down position, set the effect parameter you want to control to the desired maximum level.Optional: To set the effect parameter's minimum level, use internal potentiometer toward the front of the pedal. Turn it clockwise to raise the minimum level or counterclockwise to lower it. Note: factory setting is fully counterclockwise.Move the rocker pedal toward the heel-down position to lower the value of the effect parameter within the range set by your effect pedal's control and the Volume (X)'s internal potentiometer.When the rocker is fully heel-down, the effect parameter will be at the minimum value as set by the internal potentiometer.Optional: Use the internal blue push switch to reverse the function of heel-and toe-down postions.CONTROLSOUTPUT jack for volume signal controlFX output for effect parameter controlTUNER jack for constant signal to tunerINTERNAL 50 kg POT for setting minimum heel-down value, wired in series with expression potINTERNAL SWITCH for reversing foot/heel polarityADJUSTABLE TORQUETo adjust rocker pedal torque, place pedal in toe-down position. Insert a 1/4" flat blade screwdriver into torque adjust screw located under heel-end of rocker pedal. Turn clockwise to increase resistance or counterclockwise to decrease resistance.POWERThe Dunlop Volume (X) is a passive unit and does not require a power source to operate.DIMENSIONS OF PEDALHeight: 2.575" (65.4 mm)Width: 3.858" (98.0 mm)Length: 10.000"(253.8 mm)Weight: 2 lbs. 12 oz. (1.242 Kg)
This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.
Look up onDisclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.
