ModularGrid uses so-called cookies to ensure it's so-called functionality. We also use dubious tracking scripts. Find out more in the Privacy Policy. We use cookies and wanna let you know.
Got it.
If you had an Unicorn Account you could see a chart with the price development of this module and the average price asked for this module.
The Darkglass Microtubes B7K V2 Bass Preamp Pedal offers all the features of the original, with the ability to better sculpture your tone - on the low mids you have the option to change the center frequency from 1KHz to 500Hz, and on the high mids, you have the option to change the center frequency from 3kHz to 1.5kHz. This will enable you to tailor your absolute dream distortion tone. The character and core of the Microtubes B7K remain the same, still retaining the powerful dynamic saturation circuit of the B3K and adding a four-band equalizer and a balanced line driver for even greater versatility. Designed for both studio and live use, it will take your direct sound to a whole new level. Blend This mixes the clean input signal with the overdriven signal. The clean signal remains at unity gain while the volume of the overdriven signal is set by the Level knob, allowing for fine control of the blend ratio. Level Level control sets the volume of the overdriven signal. Drive This sets the amount of saturation in the overdriven signal. Grunt Switch This sets the amount of low-frequency content to saturate by selecting between three different bass boost levels before the clipping stage. Attack Switch The attack switch sets the amount of treble content to saturate. The 'Boost' setting emphasizes the treble content's extra clarity and presence. The 'Flat' position leaves this register untouched while the 'Cut' position will reduce the number of high frequencies being saturated. Low Mids Switch This switch changes the center frequency of the Low Mids from 1kHz to 500Hz. Hi Mids Switch This switch changes the center frequency of the Hi Mids from 3kHz to 1.5kHz. Parallel Output A passthrough for your input signal, it is useful for parallel processing. Direct Output A balanced version of the 1/4 inch output, useful for running into PAs or studio mixing consoles.*Note: The Microtubes B7K v2 has a current draw of 30mA. Only use a regulated 9V DC adapter with a center-negative plug. Due to ecological reasons, it does not accept batteries. Unregulated power supplies and/or higher voltages may result in suboptimal noise performance and even damage your unit, voiding the warranty.
This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.
Look up onDisclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.
