Stereo Reverb & Delay with Tap Tempo
https://www.earthquakerdevices.com/avalanche-run
Go to the Module Detail PageIf you had an Unicorn Account you could see a chart with the price development of this module and the average price asked for this module.
Great unit, already have another one of these, soft minor scratches as seen on pics. Does not come with power adaptor.1. Time: This controls the delay time and goes from 0ms to just under 2000ms.2. Repeats: Controls the regeneration of the delay, from zero repeats to near infinite.3. Tone: Controls the tone for the delay line only. Roll off highs to the left, roll off lows to the right and get a flat response in the middle.4. Mix: The is the volume control for the delay line. This blends in the wet with dry until 1 o’clock, 1 o’clock to 3 o’clock boosts the wet signal over the dry and 3 o’clock up brings down dry until it is fully wet when all the way up.5. Expression Jack Assign Switch: Use this switch to map the expression jack to one of the assigned controls.Decay: Controls the reverb decay lengthR Mix: Controls the reverb mixTime: This takes over for the delay time control and is DRASTICALLY different than the interface control. Using the expression pedal to control the time will give you all kinds of wild effects that can not be achieved by turning the knob.Repeats: Controls the delay repeatsD Mix: Controls the delay mixToggle: This takes over for the toggle switch and will cross fade from forward delay in heel down position to reverse delay in toe down position.6. Ratio Selector Switch: Selects delay subdivisions when time is set by the “Tap” switch.1/1: Quarter Note3/4: Dotted 8th2/3: Quarter Note Triplet1/2: 8th Note 1/3: 8th Note Triplet1/4: 16th Note7. Decay: Controls the decay length of the reverb, short decay counterclockwise, long cavernous decay clockwise.8. Toggle Switch (Mode Selector)Normal: This is the “standard” delay and reverb modeReverse: This is reverse delay mode with “standard” reverbSwell: This is the volume swell mode9. Mix: This is the volume control for the reverb. Blends in the wet with dry until 1 o’clock, 1 o’clock to 3 o’clock boosts the wet signal over the dry and 3 o’clock up brings down dry until it is fully wet when all the way up.
This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.
Look up onDisclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.