ModularGrid uses so-called cookies to ensure it's so-called functionality. We also use dubious tracking scripts. Find out more in the Privacy Policy. We use cookies and wanna let you know.
Got it.
If you had an Unicorn Account you could see a chart with the price development of this module and the average price asked for this module.
Analogman Prince of Tone in excellent condition! No visible wear to speak of and extremely low playtime! I bought this new from Analogman in 2018 and only used it once to test! I was going to put this on a small board, but I never did because I still had room for my KOT on it. It deserves to be played so take it off my hands and enjoy it!! This is a really nice Bluesbreaker type overdrive with a 3 position toggle switch that lets you choose between overdrive, boost or distortion! It has a Treble trim pot inside and also has 2 internal dip switches on the board for a low-mid lift and “turbo” distortion settings. Pedal runs on a 9v battery or an external 9-18v DC power supply (not included). Comes with original pedal box and original instructions sheet! More info from Analogman below:The POT is pretty much the same as half of the King of Tone, with an external MODE switch standard. It is the same as the KOT with HIGHER GAIN option, so the full range of the DRIVE knob is useful and it has a little more drive at the top than a normal gain KOT. The DISTORTION mode is improved though, for a louder, stronger distortion sound. See more info. Specs are very similar to the DUKE OF TONE which we later designed with MXR and also sell. Power Jack is standard on the POT.The TREBLE trimpot is inside, just like the KOT. There are also two new DIP switches inside! They are a bit subtle at some knob settings and modes:DIP1 : LO-MID lift switch. The tone from your lower strings will be enhanced a little when DIP switch is ON.DIP2: TURBO switch- with higher gain settings you'll hear deeper compression, especially in DIST mode. You will hear a brighter, crunchier sound with this on at higher DRIVE settings when this DIP switch is ON. The three modes, as on the KOT, are:1) Normal Overdrive mode (OD mode): This is the standard King Of Tone sound, - a touch drive available than a tube screamer. Can get much louder than a tube screamer. The RED side of KOT has this setting from the factory.2) CLEAN mode : This mode has less distortion, it can be used for clean boosts or clearer, louder sounds. It's sort of a cross between a true clean boost and an overdrive. CLEAN MODE is even less compressed and louder than the OD mode. I love this mode with high drive settings too! The YELLOW side of KOT has this setting from the factory.3) DISTORTION mode : more distortion than the overdrive mode- a touch of hard distortion. The sound is more compressed, yet retains the pedal's character. Same volume as OD mode.At low DRIVE settings, or when playing softly, there is not much difference between the three modes, they all can get pretty clean and have the same level at low drive settings. The ability to clean up when playing softly is a very useful feature of this pedal. The DRIVE knob taper is different than the KOT. It comes up faster and more linear, while KOT has a lot going on from 2:00 to max. So comparison to a KOT with HG option will not be the same at the same knob position unless it's up all the way, where they are the same. POWER SUPPLY: A Standard Boss PSA120 type 9V DC adapter will work fine. Center is negative. The pedal uses only about 6mA of current at 9V. You can get a fuzzier sound if you want, at lower voltages, for example the SAG mode on the pedalpower2. When your battery dies you will notice the pedal will not get nice and clean, the sound will be hairier. Use a good Alkaline battery or a power supply for best results. You can use higher voltage for more headroom, 12V is common, 18V is safe too. Clean boost may be improved the most with higher voltage.CHIPS: You can also try other standard dual op-amp chips in the Prince of Tone. Just make sure you put it in the right way, with the pin#1 dot on the side with the chip socket cut-out. The TS-808's JRC4558D chip sounds good in this pedal, especially with single coil guitars and smaller Fender type amps. You can try a high fidelity chip for the CLEAN mode which may work well.
This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.
Look up onDisclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.
