Empress Chorus

Description

Great sounding comprehensive Chorus/Vibrato pedal - with dark switch to tame any classic BBD noise.Listed for cheaper on EbayMix – This determines how much wet signal is mixed in with the dry. Wet to the right, dry to the left. Depth - Allows you to control the depth of the effected sound Voicing - This dial allows you to access virtually any chorus sound you could desire! It changes the delay time – it’s on a pot so you’ve got an infinite number of chorus pedals in one box – from super spanky sparkling clean to noisy, sea sick inducing, pitch bending wobble. Delay time determines a big part of any chorus units tone/flavour/sound - short delay creates a very pristine, airy chorus whereas longer delay time gives more ‘wobble’ and ‘throb’. Unfortunately virtually all devices available only have one fixed delay setting – or at most a choice of two or three..... We’ve designed a circuit that lets you adjust the delay time via a potentiometer – from one extreme to the other and everything in between. In its most extreme settings the device will produce some hiss – this would be expected within the last third of the voicing controls sweep. You may hear a faint crackle as the voice control is turned – this is normal – it’s adjusting a DC bias on the BBD chip. Nothing to worry aboutVelocity - This dial allows you to select the speed of the sweep. From Stand Still Slow to Ring-moddishly Fast. Vibe/Chorus Switch - Choose between Chorus or Vibrato mode. When in vibrato mode you can use the voicing dial to choose from gentle, subtle pitch shifting through to wild semitone leaps. The voicing control functions in vibe mode the same way it does in chorus mode – it shifts the delay time. Nasty or Nice – you choose. Stereo Out = The lower left socket .The Empress loves to function in stereo – harness her to two amplifiers and stand in between them – one will carry the dry signal and the other will carry the wet. The chorusing occurs in the air between the amps. Neat. If you find the wet signal to be louder than the dry simply switch the vibe/chorus switch – this will reduce the output of the wet signal.Colour switch - This allows you to select between bright mode (for the sparkly of sparkly chorus tones) or dark mode (for access to the darker tones of the classic old analog chorus pedals). Access some more sparkle on the more shimmery settings. When using bright mode you will notice some top end hiss when using the more extreme voice settings (last 1/3 of the voice sweep). You get the sparkle because we are removing the high end roll off that would usually eliminate the hiss. If you don’t want the hiss, use Dark Mode. Internal slide switch - The Empress has two different input stages – the slide switch lets you choose between them. The unit is preset by us to the higher gain input stage setting. The other position provides a little more pad and slightly different tonal response. Feel free to try both.Switching - The Empress uses True Bypass switching. When she’s not turned on she’s just like a piece of guitar cable. Power - The Empress can only be run from external nine volt adapter (Boss PSA styled is ideal - though anything with a 2.1mm barrel plug with a negative center pin is fine.). However, you can use up to 15 volts, should you desire more headroom. The Empress Deus requires a minimum of 25mA to happily run.

This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.

Disclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.