Face the Fuzz

Fuzz Face Clone

Virtually Zero control. It is fuzz, albeit a good fuzz, with limited tone control.

2 controls – Fuzz & Level – to tweak your tone. Fuzz sends your tone from subtle to razor blades and Level adjusts your output level for boosts. An on-board bias trim pot (accessed by unscrewing the back panel) lets you adjust transistor bias level for a variety of new Fuzz tones!
Uses temperature-stable BC558 silicon transistors or NOS Germanium AC128 Transistors.
Wider frequency response than the Arbiter Fuzz Face Clone.
3PDT switch allows for true bypass switching and LED indicator gives you a visual cue when your circuit is engaged and using power
Dual power supplies allow you to have the battery as backup or as the main power. Use a 9V Battery and 9V center negative DC adapter (can be daisy-chained by using a 1 Spot or equivalent adapter)
Input jack switching – No instrument cable plugged in, no power used. Save life on your expensive batteries!
Stomp-ready graphics on a powder-coated white case (complete version only – kits come with an unpainted case and no graphic)
DIYers can choose between a PCB-mount kit or a wired kit
PCB silkscreen, through-hole components with careful on-board placement, and wire-tension relief holes were designed with the DIYer in mind!
PCB Dimensions: 2 1/8″ x 3 1/8″ (5.4cm x 7.9cm)

https://www.synthrotek.com/products/effect-pedal-circuits/face-the-fuzz/