Hi all!
I have just installed HammerPWR into my case (Nono Lander Two, just in case you were wondering ;-). All is fine so far, but I have stumbled over this question, that I cannot seem to find an answer to:
On the HammerPWR board there are the two sets of Wago connectors which lead to the bus boards, so far so good. The manual recommends to evenly load these two sets, also clear. Where does the 16-pin IDC connector fit in, though; is it somehow limited or does it draw power from one of the sides? Or does it have any other features?
Thanks Ron
ModularGrid uses so-called cookies to ensure it's so-called functionality. We also use dubious tracking scripts. Find out more in the Privacy Policy. We use cookies and wanna let you know.
Got it.