Thanks, Ronin, for both of your replies, and I apologize if my first post sounded harsher than it needed to.
I’m not sure I agree with everything you wrote here. I’m not especially familiar with the Mother 32 but it seems like a very capable synth in it’s own right. The prospect of integrating it with a small eurorack setup that includes Disting, Tides, Maths, and Shades, and then adding some of the modules that placebo suggested (Strymon Magneto, Intellijel Rainmaker, MI Clouds, Make Noise Erb-Verb, Tiptop Z-DSP) seems to me far from “just piling on the bad.” It seems a bit strange to me that you can agree with the creative potential of a slinky or Pringles can (which I agree with too btw) but make the statement you did about the above setup. (It’s also worth noting that Lugia agreed with placebo’s recommendation to add effects modules to this rack.)
I apologize if these posts of mine aren’t helping as that’s really my intention, but I feel like the following point is valid: I think statements like yours above, and the quotes of Lugia’s that I’ve referenced, may in fact do just as much harm to the genre of synthesis than less-than-perfect setups that require the user to make adjustments as they begin to learn more.
I also think it’s possible there may be a bit more space for different approaches to a modular setup than it seems you and Lugia believe. An example… A rack that was posted a few days ago received the following criticism: “There's an Elements...and a Rings? OK with the Department of Redundancy Department, perhaps, but a waste of space otherwise. Lose one or the other.” Note they didn’t merely point out that these two modules are similar; they more or less gave an order. Yet I recall a video popping up in my youtube suggestions recently that featured a 6U case that not only had Elements and Rings, but Elements + two Rings (all three of which were being used). If I remember correctly it was quite lovely, had thousands of views and many enthusiastic comments. Might the OP of that thread have benefited from using both of those modules in a rack that was 12U / 84HP? I don’t know, but I think it’s reasonable to suggest that it’s a possibility.
Look: I hope it goes without saying that I’m not trying to start anything, or to insult anyone personally. We both agree that modular synths are wonderful instruments, and I agree that many people likely don’t do the necessary research required to get into this – that they post racks with serious flaws and that they benefit greatly from the advice of you, Lugia, and others… With a subject that can be so daunting though (it terms of learning curve and cost) I’ve found what I see as an unnecessary level of discouragement in many of the posts I’ve come across.