Pedal Power 2 PLUS

Description

I'm a writer not a player so this was in my studio for my guitar setup for writing purposes, but seldom used. So it's in great shape. Never left the studio. Nice quiet, reliable power for your guitar pedals. I'm only getting rid of it because I upgraded to Power 3 Plus for more outputs. I would rate it Excellent condition except it IS from 2010.Comes with power cable, manual, eight (8) 2.1mm standard center negative polarity cables: Six (6) standard 18” and two (2) 24”. Also one cable with a 9V battery type snap connector to connect to your pedal's 9V battery connector (for old pedals which have no other power input except battery). NOTE: Does NOT contain the red barrel reverse polarity cable for Line 6 modelers and the like. Does NOT contain the 3.5 mm mini plug cable.Description from Voodoo Labs: "The 2 PLUS is equipped with eight galvanically isolated 9V outputs, including six outputs switchable to 12V, two 250mA outs for more power-hungry effects, and two outputs featuring a SAG function that simulates the output of a low battery. 18V and 24V operation is also available by combining outputs with available special cabling. A handy onboard 200-watt courtesy outlet is included for powering an additional device such as an AC-powered effect, wireless system, or another power supply. Pedal Power 2 PLUS is ideal for small to medium pedalboards or as a supplemental power supply in a larger rig.""9/12V (x4) – Standard 9V and 12V Boss ACAWith each one of these four outputs delivering 100mA, you can easily power any 9V battery-operated pedals. Boss pedals that specify the PSA adapter operate at 9V like most other pedals. Boss pedals that require the ACA adapter operate at 12V which can be selected via switches underneath the Pedal Power 2 PLUS. Any one of these outputs can be individually selected to run at 9V or 12V.9V (x2) – High Current 9V and Line 6 ModelersThese two outputs each deliver 250mA allowing you to run high current draw effects like the Boss DD-20 Giga Delay or Line 6 DL4 Delay Modeler. Via switches underneath the Pedal Power 2 PLUS, these two outputs can be separately configured for regulated (Boss Twin Pedals) or unregulated (Line 6 Modelers) power allowing you to run both units if so desired. These outputs can also power any standard 9V effects as well.9V (x2) – Standard 9V With Battery Sag ControlThese outputs each have an available 100mA of power, but also allow you to SAG the voltage from roughly 4V to 9V. This feature can be enabled via the bottom panel switches. The SAG control is mostly useful for transistor-based fuzz, octavia, and distortion circuits, as most modern opamp designs are minimally affected by variations in supply voltage. We recommend turning SAG off if you’re going to run digital pedals like delay, chorus, and reverb.18V/24V – Using Custom CablesAll of the outputs on the Pedal Power 2 PLUS are completely isolated allowing you to create different voltages. You can run effects like the current MXR Flanger by combining two 9V outputs to create a single 18V supply. By switching two outputs into 12V ACA mode, you can join them together to create a 24V output for powering numerous Electro-Harmonix stompboxes including the Deluxe Memory Man."

This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.

Disclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.