Dimensions
1 U
45 mm deep
Current Draw
Module does not draw current
Price
$106 Price in €

This Module is currently available.

Attenuator

FUNCTION DESCRIPTION SW995

The SW995 Attenuators panel consists of three „passive circuits“, each made of a 25k potentiometer between input and output. The signal input to the top attenuator is chained to the bottom two in series. Introduction of a patch cord into middle or bottom input breaks the normalling system. Attenuators reduce the gain or amplitude of any applied input signal, control or audio. Moving clockwise from zero gain to unity gain with input, these attenuators can be used for reducing the effect of a control upon a voltage controlled module, providing up to three variable outputs from a single source input or reducing the gain of an entire signal complex.

This Module is based on the original design from 1968

http://www.synth-werk.com/content/modules


submitted Feb 21st 2017, 00:45 by StingR | last Change Aug 5th 2017, 14:36 by analogdarkside
Affiliate Disclosure
This page contains affiliate links from eBay, Reverb.com and other partners for which ModularGrid may be compensated.